Keyless Operation Does Not Work (LOCK, UNLOCK, PANIC)
NOTE:
- If the LOCK and UNLOCK buttons work OK, but the PANIC button does not, see the troubleshooting for the horn does not sound and/or the headlights do not flash when the PANIC button on the transmitter is pressed (see THE HORN DOES NOT SOUND AND/OR THE HEADLIGHTS DO NOT FLASH WHEN THE PANIC BUTTON ON THE TRANSMITTER IS PRESSED )
- Before troubleshooting, check the B-CAN DTCs. If any DTC is indicated, refer to the B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ), and troubleshoot the indicated DTC(s) first.
- Insert the key into the ignition switch, but leave the switch in LOCK (0).
- Open the driver's door, and listen for the key-in reminder beeper.
Does the beeper sound?
YES -Go to step 3.
NO -Test the ignition key-in reminder circuit, and recheck.
- Turn the ignition switch to ON (II).
- Try to start the engine.
Does the engine start?
YES -The immobilizer system is OK, Go to step 5.
NO -Go to the immobilizer symptom troubleshooting (see SYMPTOM TROUBLESHOOTING ).
- Turn the ignition switch to LOCK (0).
- Test the transmitter (see TRANSMITTER TEST ).
Is the transmitter OK?
YES -Faulty keyless receiver, replace the power window master switch (see POWER WINDOW MASTER SWITCH REPLACEMENT ).
NO -Replace the transmitter.