Ignition Key Light Test

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ), before doing repairs or servicing.

1. Remove the steering column upper and lower covers (see REMOVAL ).
2. Disconnect the 6P connector.
   Fig 1: Identifying Ignition Key Switch 6P Connector Terminals

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. The LED should come on when power is connected to terminal No. 6 and ground is connected to terminal No. 5.
4. If the LED does not come on, replace the steering lock.