LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2012 >> Ridgeline RT >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> A/T Gear Position Indicator >> Transmission Range Switch Test

Transmission Range Switch Test

  1. Do the battery removal procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then remove the battery tray.
  2. Remove the engine cover, the air intake duct, the resonator, and the air cleaner housing.
  3. Remove the battery base.
  4. Disconnect the transmission range switch connector.
    Fig 1: Identifying Transmission Range Switch Connector Terminals
    G06628950Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position.

    Transmission Range Switch Connector 

    Fig 2: Terminals Range Switch Connector Continuity Chart
    G06628951Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. The transmission range switch test is finished if the test results are OK. If there is no continuity between any terminals, check the transmission range switch installation. If the transmission range switch installation is OK, replace the transmission range switch (see TRANSMISSION RANGE SWITCH REPLACEMENT ).
  7. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
  8. Install the battery base bracket and the battery base.
  9. Install the air cleaner housing, the resonator, the air intake duct, and the engine cover.
  10. Install the battery tray, then do the battery installation procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
scientia non olet · About LEMON Manuals