Center Console Trim Disassembly/Reassembly

NOTE: Take care not to scratch the armrest.

Remove the center console trim (see step 2 on CENTER CONSOLE REMOVAL/INSTALLATION ).
Disassemble the center console trim.
1. -1 Disconnect the accessory socket connector (A) and the light bulb socket (B), and detach the harness clips (C).
2. -2 Remove the screws (D), using a TORX T20 bit, then remove the console vent (E) and the console duct (F).
3. -3 Remove the screws (G), using a TORX T20 bit, then remove the hooks (H).
Fig 1: Identifying Accessory Socket Connector, Light Bulb Socket, Harness Clips Console Vent And Console Duct
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reassemble the console in the reverse order of disassemble, and make sure the accessory socket connector and the light bulb socket are plugged in properly.