LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2012 >> Odyssey EX >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Block >> Oil Pan Removal

Oil Pan Removal

  1. If the engine is already out of the vehicle, go to step  6
  2. Raise the vehicle on the lift.
  3. Drain the engine oil (see ENGINE OIL REPLACEMENT ).
  4. Remove the inner fender (see FRONT INNER FENDER REPLACEMENT ).
  5. Remove exhaust pipe A (see step 31 in ENGINE REMOVAL ).
  6. Remove the rear warm up TWC bracket.
    Fig 1: Identifying Rear Warm Up TWC Bracket And Exhaust Pipe
    G06966438Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the CKP sensor cover (A) and the bolt (B), then disconnect the CKP sensor connector (C).
    Fig 2: Identifying CKP Sensor Connector, CKP Sensor Cover And Mounting Bolt
    G06966439Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Remove the torque converter case cover (A) and the four bolts (B) securing the transmission.
    Fig 3: Identifying Torque Converter Case Cover With Mounting Bolts
    G06966440Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Remove the bolts securing the oil pan.
  10. Using a flat blade screwdriver, separate the oil pan from the engine block in the places shown.
    Fig 4: Identifying Oil Pan Separating Position
    G06966441Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Remove the oil pan.
scientia non olet · About LEMON Manuals