Window Position Switch Test

Remove the sliding door panel (see SLIDING DOOR PANEL REMOVAL/INSTALLATION ).
Disconnect the 2P connector (A) from the window position switch (B).

Fig 1: Identifying 2P Connector And Window Position Switch Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.
NOTE: Do not touch the sliding door while the window is moving.

Fig 2: Checking For Continuity Between Terminals In Each Switch Position
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, replace the window position switch (see SLIDING DOOR GLASS AND REGULATOR REPLACEMENT ).