Sliding Door Beeper Logic

This buzzer alerts the driver and occupants that the sliding door system requires attention for safety reasons. The buzzer operates in three modes:

Three Beep-Buzzer sounds for 500 ms and then is off for 250 ms three times; this tone applies during the following conditions:

• When power sliding door keyless open mode has been customized to "WHEN UNLOCKED" (without multi-information display)
• Trap detection operation
• Emergency stop operation
• Power slide door open operation is requested from the remote transmitter or power sliding door switch on the dashboard while the door is locked.
• Power slide door close operation is requested while the touch sensor is ON.
• Power slide door open operation is requested while the fuel fill door is open.

Continuous Tone-Buzzer sounds a solid, continuous tone until the condition causing the warning is eliminated. This tone applies during the following conditions:

• The door is not fully closed, the vehicle is not stopped, and the shift lever is out of P with the foot brake or parking brake OFF.
• The door is not fully closed and the vehicle speed (VSP) or wheel speed (VSPWHEEL) is not zero.
• Unintentional Slide Prevention is active (electromagnetic clutch is on).

Continuous Beep-Buzzer sounds for 500 ms and then is off for 250 ms, and continuously repeats until the condition causing the warning is eliminated. This tone applies during the following conditions:

• The door is closing while the vehicle speed (VSP) or wheel speed (VSPWHEEL) is not zero.
• The door is closing while the shift lever is out of P with the foot brake and parking brake OFF.
• When power sliding door keyless open mode has been customized to "ANYTIME" (without multi-information display)