LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2012 >> Odyssey EX >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Gauges >> Gauge Control Module Replacement

Gauge Control Module Replacement

NOTE: Before replacing the gauge control module, retrieve the ODO data from the gauge control module with the HDS (see REWRITING THE ODO DATA ON A NEW GAUGE CONTROL MODULE ).
  1. Turn the ignition switch to LOCK (0).
  2. Remove the instrument visor (see INSTRUMENT VISOR REMOVAL/INSTALLATION ).
  3. Remove the three screws from the gauge control module (A).
    Fig 1: Identifying Gauge Control Module With Connector Terminals
    G06969999Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the 32P connector (B) from the gauge control module.
  5. Install the gauge control module in the reverse order of removal.
  6. Rewriting the ODO data on a new gauge control module (see REWRITING THE ODO DATA ON A NEW GAUGE CONTROL MODULE ).
    NOTE: Check the official Honda website for more information on how to write odometer information to a gauge control module that will not communicate with the HDS.
scientia non olet · About LEMON Manuals