LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2012 >> Insight Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Keyless/Power Door Locks/Security System) >> Symptom Troubleshooting >> Hatch latch switch circuit troubleshooting

Hatch latch switch circuit troubleshooting

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to ON (II).
  2. With the hatch closed, select SECURITY with the HDS, and enter the DATA LIST.
  3. Check the ON/OFF information of the TRUNK LID/TAIL GATE SWITCH in the DATA LIST.

    Is the data list value indicated ON? 

    YES  -Go to step 4.

    NO  -Go to step  8.

  4. Disconnect the hatch latch switch 2P connector.
  5. Check the ON/OFF information of the TRUNK LID/TAIL GATE SWITCH in the DATA LIST.

    Is the data list value indicated OFF? 

    YES  -Faulty hatch latch switch, replace the hatch latch (see HATCH LATCH REPLACEMENT ).

    NO  -Go to step 6.

  6. Disconnect under-dash fuse/relay box connector C (49P).
  7. Check for continuity between under-dash fuse/relay box connector C (49P) terminal No. 22 and body ground.
    Fig 1: Checking Continuity Between Under-Dash Fuse/Relay Box Connector C (49P) Terminal No. 22 And Body Ground
    G00500491Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Repair a short to ground in the wire.

    NO  -Faulty MICU; replace the under-dash fuse/relay box.

  8. Disconnect the hatch latch switch 2P connector.
  9. Connect hatch latch switch 2P connector terminal No. 2 and body ground with a jumper wire.
    Fig 2: Connecting Hatch Latch Switch 2P Connector Terminal No. 2 And Body Ground
    G00500492Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Check the ON/OFF information of the TRUNK LID/TAIL GATE SWITCH in the DATA LIST.

    Is the data list value indicated ON? 

    YES  -Go to step 11.

    NO  -Go to step  12.

  11. Check for continuity between hatch latch switch 2P connector terminal No. 1 and body ground.
    Fig 3: Checking Continuity Between Hatch Latch Switch 2P Connector Terminal No. 1 And Body Ground
    G00500493Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Faulty hatch latch switch; replace the hatch latch (see HATCH LATCH REPLACEMENT ).

    NO  -Repair an open or high resistance in the wire or poor ground (G801).

  12. Connect under-dash fuse/relay box connector C (49P) terminal No. 22 and body ground with a jumper wire.
    Fig 4: Connecting Under-Dash Fuse/Relay Box Connector C (49P) Terminal No. 22 And Body Ground
    G00500494Courtesy of AMERICAN HONDA MOTOR CO., INC.
  13. Check the ON/OFF information of the TRUNK LID/TAIL GATE SWITCH in the DATA LIST.

    Is the data list value indicated ON? 

    YES  -Repair an open or high resistance in the wire.

    NO  -Faulty MICU; replace the under-dash fuse/relay box.

scientia non olet · About LEMON Manuals