Navigation Display Buttons Do Not Work or Respond Properly
WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Check the vehicle battery condition first.
- Confirm the correct DVD color and version disc is installed in the audio-navigation unit (see DVD HANDLING AND CLEANING ) as the wrong DVD or software version can cause a hardware malfunction.
- Check the connectors for poor connections or loose terminals.
- Inspect the DVD for dirt or damage.
- Check any official Honda service website for more service information about the navigation system.
- Before troubleshooting, make sure you have anti-theft code for the audio-navigation system.
- After troubleshooting, enter the anti-theft code for the audio-navigation system if necessary.
- Turn the ignition switch to ON (II).
Does the navigation display turn on?
YES - Go to step 2.
NO - Refer to troubleshooting for no picture is displayed (see SYMPTOM TROUBLESHOOTING ).
- Try to enter the navigation system diagnostic mode (see SYSTEM DIAGNOSTIC MODE
).
Does the navigation system enter into the system diagnostic mode?
YES - Go to step 3.
NO - Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).
- Go into Detail Information & Settings, and select Unit Check, then do the Hard Key Test.
Do all the hard buttons around the display function properly?
YES - Intermittent failure, the system is OK at this time.
NO - Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).