Intake Manifold Removal and Installation: Installation

Reassemble the intake manifold.
NOTE: Refer to the EXPLODED VIEW if needed during this procedure.
Install the intake manifold (A) with new gaskets (B).
NOTE: Tighten the bolts and nuts in a crisscross pattern in three steps, beginning with the inner bolt.

Fig 1: Intake Manifold, Gaskets With Mounting Bolts Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the engine wire harness holder (A) and the dipstick (B).

Fig 2: Engine Wire Harness Holder, Dipstick, PCV Hose And EGR Valve Connector With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect the PCV hose (C) and the EGR valve connector (D).
Install the engine cover.

Fig 3: Identifying Engine Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.