Carrier Bearing Replacement

Special Tools Required 

Driver Handle, 40 mm I.D. 07746-0030100

1. Remove the carrier bearings (transmission housing side and flywheel housing side) (A) using a commercially available puller (B) and a spacer (C), and replace the carrier bearings.
   Fig 1: Removing Carrier Bearings (Transmission Housing Side And Flywheel Housing Side) Using Commercially Available Puller And Spacer

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install new bearings (A) in the direction shown on the differential carrier (B) using the 40 mm driver handle and a press. Press the bearing on until it bottoms.
   Fig 2: Installing Bearings In Direction Shown On Differential Carrier Using 40 mm Driver Handle And Press

   Courtesy of AMERICAN HONDA MOTOR CO., INC.