LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2011 >> Pilot EX, 3.5 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Automatic Transmission) >> Shift Lever Installation

Shift Lever Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift lever assembly (A) on the steering column.
    Fig 1: Shift Lever Assembly On Steering Column With Torque Specifications
    G06628876Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Connect the 7P connector (B) to the immobilizer control unit-receiver.
  3. Connect the D3 switch/shift lock solenoid/park pin switch connector (C), and install the harness clamp (D) and connector clamp on the bracket (E).
  4. Turn the ignition switch to ON (II), and check that the R position indicator comes on.
    Fig 2: Identifying R Position Indicator
    G06628877Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. If necessary, push the shift cable (A) until it stops, then release it. Pull the shift cable back one step so that the shift position is in R. Do not hold the shift cable guide (B) and the damper (C) to adjust the shift cable.
    Fig 3: Identifying Shift Cable, Cable Guide And Damper
    G06628878Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Turn the ignition switch to LOCK (0).
  7. Place the shift lever in R, then insert a 6.0 mm (0.24 in) pin (A) through the positioning hole (B) on the shift lever link, and into the positioning hole on the shift lever bracket. The shift lever (C) is secured in R.
    Fig 4: Inserting Pin Through Positioning Hole On Shift Lever Link
    G06628879Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Rotate the socket holder (A) on the shift cable (B) to place the tab (C) on the holder opposite to the opening (D) in the socket holder bracket (E). Align the holder with the opening (F) in the bracket, then slide the holder into the bracket. Rotate the holder a quarter turn until the holder lock (G) stops at the projection (H) to secure the shift cable. Do not install the shift cable by twisting the shift cable guide (I) and the damper (J).
    Fig 5: Installing Shift Cable
    G06628880Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Install the shift cable end (A) in the shift cable end holder (B). Keep the shift cable end and end holder free of grease.
    Fig 6: Identifying Shift Cable End And Shift Cable End Holder
    G06628881Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Install a new shift cable lock (A) to secure the shift cable end and shift cable end holder, then slide the lock tab (B) toward the shift lever link until it stops to lock the joint (C).
    Fig 7: Identifying Shift Cable Lock, Lock Tab And Joint
    G06628882Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Remove the 6.0 mm (0.24 in) pin that was installed to hold the shift lever.
  12. Move the shift lever to each position, and check that the A/T gear position indicator follows the transmission range switch.
  13. Install the steering column covers (see STEERING COLUMN REMOVAL AND INSTALLATION ).
  14. Install the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ).
scientia non olet · About LEMON Manuals