LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2011 >> Pilot EX, 3.5 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Engine Block) >> Oil Pan Removal

Oil Pan Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the engine is already out of the vehicle, Go to step  6.
  2. Raise the vehicle on the lift.
  3. Drain the engine oil (see ENGINE OIL LEVEL CHECK ).
  4. Remove the splash shield (see FRONT SPLASH SHIELD REPLACEMENT ).
  5. Remove exhaust pipe A (see EXHAUST PIPE AND MUFFLER REPLACEMENT ).
  6. Remove the rear WU-TWC bracket.
    Fig 1: Identifying Bracket And Bolts
    G05964168Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the crankshaft position (CKP) sensor cover (A) and the bolt (B), then disconnect the CKP sensor connector (C).
    Fig 2: Identifying Crankshaft Position Sensor Cover And Bolt
    G05964169Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Remove the clutch/torque converter cover (A) and the four bolts (B) securing the transmission.
    Fig 3: Identifying Clutch/Torque Converter Cover And Bolts
    G05964170Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Remove the bolts securing the oil pan.
  10. Using a flat blade screwdriver, separate the oil pan from the engine block in the places shown.
    Fig 4: Identifying Oil Pan Bolts
    G05964171Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Remove the oil pan.
scientia non olet · About LEMON Manuals