LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2011 >> Pilot EX, 3.5 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Starting System) >> Starter Solenoid Test

Starter Solenoid Test

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the battery terminal disconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
  2. Remove the harness clamp (A), then disconnect the positive starter cable (B), the motor wire (C), and the 1P connector (D).
    Fig 1: Harness Clamp And Starter Cable With Torque Specifications
    G05963841Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). There should be continuity.
    • If there is continuity, Go to step 4.
    • If there is no continuity, replace the solenoid.
  4. Check the pull-in coil for continuity between the S terminal and the M terminal. There should be continuity.
    • If there is continuity, the solenoid is OK.
    • If there is no continuity, replace the solenoid.
  5. Connect the wire and the connector in the reverse order of removal.
  6. Do the battery terminal reconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
scientia non olet · About LEMON Manuals