LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2011 >> Pilot EX, 3.5 4 >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Windows >> Front Passenger's Power Window Motor Test >> Motor Test

Motor Test

  1. Remove the front passenger's power window switch (see FRONT PASSENGER'S POWER WINDOW SWITCH REPLACEMENT  ).
  2. Test the motor in each direction by connecting battery power and ground to the front passenger's power window switch 37P connector (A) according to the table below.
    Fig 1: Identifying Battery Power Ground Connection Reference Table
    G05966382Courtesy of AMERICAN HONDA MOTOR CO., INC.
    Fig 2: Identifying Front Passenger's Power Window Switch 37P Connector
    G05966383Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. If the motor does not run or fails to run smoothly, go to step  4, if the motor runs smoothly, go to step.
  4. Remove the door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  5. Disconnect the 6P connector (A) from the front passenger's power window motor (B).
    Fig 3: Identifying Front Passenger's Power Window Motor 6P Connector
    G05966384Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Check for continuity between front passenger's power window switch 37P connector terminals No. 12 and No. 24 and front passenger's power window motor 6P connector terminals No. 1 and No. 4 respectively. There should be continuity.
    CONNECTOR TERMINAL REFERENCE TABLE

    FRONT PASSENGER'S POWER WINDOW SWITCH 37P CONNECTOR  FRONT PASSENGER'S POWER WINDOW MOTOR 6P CONNECTOR 
    Terminal No. 12 Terminal No. 4
    Terminal No. 24 Terminal No. 1
    Fig 4: Checking Continuity Between Power Window Switch 37P & Power Window Motor 6P Connectors
    G05966385Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. If there is no continuity, repair an open or high resistance in the wires. If the wire harness in OK, replace the front passenger's power window motor (see FRONT DOOR GLASS AND REGULATOR REPLACEMENT ).
  8. Hall IC unit (Pulser) Test 

  9. Check for continuity between front passenger's power window motor 6P connector terminal No. 2 and body ground. There should be continuity.
    • If there is continuity, go to step 9.
    • If there is no continuity, check for an open or high resistance in the BLK wire or poor ground (G404).
    Fig 5: Power Window Motor 6P Connector Terminal No. 2 And Body Ground
    G00511128Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Do the front passenger's power window switch input test at terminals No. 26, No. 27, No. 28 and No. 36 (see FRONT PASSENGER'S POWER WINDOW SWITCH INPUT TEST  ).