PCM Inputs and Outputs at Connector A (■) (44P)
PCM INPUTS AND OUTPUTS AT CONNECTOR A TERMINAL REFERENCE
| Terminal Number | Wire Color | Terminal Name | Description | Signal |
|---|---|---|---|---|
| A1 | LT GRN | VBSOL (POWER SOURCE FOR SOLENOID VALVES) | Power source for solenoid valves | With ignition switch ON (II): battery voltage |
| A6 | PUR | MRLY(PGM-FIMAIN RELAY 1) | Drives PGM-FI main relay 1 | With ignition switch ON (II): about 0 V With ignition switch OFF: battery voltage |
| A8 | YEL | IGP1 (POWER SOURCE 1) | Power source for PCM circuit | With ignition switch ON (II): battery voltage |
| A27 | GRY | SLS (SHIFT LOCK SOLENOID) | Drives shift lock solenoid | With ignition switch ON (II), in the P, brake pedal pressed, and accelerator released: about 0 V |
| A30 | YEL | S-UPP (PADDLE SHIFTER+ UPSHIFT SWITCH) | Detects paddle shifter + (upshift switch) signal | In S with paddle shifter + (upshift switch) pressed: about 0 V In S with paddle shifter + (upshift switch) released: battery voltage |
| A31 | BRN | SCS (SERVICE CHECK SIGNAL) | Detects service check signal | With service check signal shorted using the HDS: about 0 V With service check signal opened: about 5.0 V |
| A32 | LT GRN | S-DNP (PADDLE SHIFTER-DOWNSHIFT SWITCH) | Detects paddle shifter - (downshift switch) signal | In S with paddle shifter- (downshift switch) pressed: about 0 V In S with paddle shifter- (downshift switch) released: battery voltage |
| A36 | WHT | CANH (CAN COMMUNICATION SIGNAL HIGH) | Sends communication signal | With ignition switch ON (II): pulses (2.5 V) |
| A37 | RED | CANL (CAN COMMUNICATION SIGNAL LOW) | Sends communication signal | With ignition switch ON (II): pulses (2.5 V) |
| A38 | GRN | IMACANH (CAN COMMUNICATION SIGNAL HIGH) | Detects communication signal to motor control module (MCM) | With ignition switch ON (II): pulses (about 2.5 V) |
| A39 | PNK | IMACANL (CAN COMMUNICATION SIGNAL LOW) | Detects communication signal to motor control module (MCM) | With ignition switch ON (II): pulses (about 2.5 V) |
| A40 | WHT | BKSW (BRAKE PEDAL POSITION SWITCH) | Detects brake pedal position switch signal | With ignition switch ON (II) and brake pedal released: about 0 V With ignition switch ON (II) and brake pedal pressed: battery voltage |
| A43 | YEL | IGP2 (POWER SOURCE 2) | Power source for PCM circuit | With ignition switch ON (II): battery voltage |