LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2011 >> Civic GX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Electronic Throttle Control System (K20Z3 Engine)) >> Accelerator Pedal Module Removal/Installation >> Removal ('06-08 Models)

Removal ('06-08 Models)

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the accelerator pedal module connector (A), then remove the nuts (B).
    Fig 1: Disconnecting Accelerator Pedal Module Connector (With Specifications)
    G04666043Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Push the tab (C).
  3. Pry the accelerator pedal module to right and left, and remove the accelerator pedal module (D).
    NOTE:
    • The APP sensor is not available separately.

      Do not disassemble the accelerator pedal module.

    • If the tab or tab receivers (E) are damaged, pull back the carpet, remove the nut (F), and replace the pedal stop (G).
    • If the tabs (H) of the accelerator pedal module are damaged, replace the accelerator pedal module.
scientia non olet · About LEMON Manuals