LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2011 >> Civic GX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Fan Controls (K20Z3 Engine)) >> Symptom Troubleshooting Index

Symptom Troubleshooting Index

WARNING: This page is about a different variant/trim than selected.
SYMPTOM TROUBLESHOOTING INDEX

Symptom Diagnostic Procedure Also check for
Engine overheats
  1. Check the coolant level.
  2. Check for any engine coolant leakage (from gaskets, hoses, O-rings, etc.).
  3. Check for dirt, leaves, or insects on radiator and condenser.
  4. Check for deteriorated coolant.
  5. Check for a damaged or deformed fan shroud.
  6. Inspect the fan motors (see FAN MOTOR TEST ) or fan relays (see POWER RELAY TEST ).
  7. Check the radiator cap (see RADIATOR CAP TEST ).
  8. Check the thermostat (see FAN MOTOR TEST ).
  9. Inspect the water pump (see WATER PUMP INSPECTION ).
  10. Check for a plugged or deteriorated radiator hoses.
  11. Check for plugged heater core or hoses.
  12. Check for a damaged cylinder head gasket.
  
The A/C condenser fan runs at low speed, but it does not run at high speed when the engine coolant temperature is above 199 °F (93 °C) A/C condenser fan high speed circuit troubleshooting (see A/C CONDENSER FAN HIGH SPEED CIRCUIT TROUBLESHOOTING ). Cleanliness and tightness of all connectors
With the A/C off and the engine coolant temperature at 199 °F (93 °C) or below, the radiator fan runs at high speed and the A/C condenser fan does not run. When the engine coolant temperature is above 199 °F (93 °C), both fans run at high speed Remove the fan control relay, and test.
  • If the relay is faulty, replace it.
  • If the relay is OK, check for a short in the wire between the fan control relay 5P socket terminal No. 1 and radiator fan motor 2P connector terminal No. 1.
 Cleanliness and tightness of all connectors
Both the radiator fan and the A/C condenser fan run at high speed with the ignition switch ON (II), the A/C off, and the engine coolant temperature below 194 °F (90 °C) Check for short in the wire between A/C condenser fan relay 4P socket terminal No. 3 and ECM connector terminal A5. Cleanliness and tightness of all connectors
Both the radiator fan and the A/C condenser fan run at low speed with the ignition switch ON (II) and the A/C off Check for short in the wire between radiator fan relay 4P socket terminal No. 4 and ECM connector terminal A4. Cleanliness and tightness of all connectors
Both the radiator fan and the A/C condenser fan do not run at low speed with the A/C on Radiator and A/C condenser fans low speed circuit troubleshooting (see RADIATOR AND A/C CONDENSER FAN LOW SPEED CIRCUIT TROUBLESHOOTING ). Cleanliness and tightness of all connectors
Both the radiator fan and the A/C condenser fan run at low speed, but the radiator fan does not run at high speed when the engine coolant temperature is above 199 °F (93 °C) RADIATOR FAN HIGH SPEED CIRCUIT TROUBLESHOOTING  (see ). Cleanliness and tightness of all connectors
Both the radiator fan and the A/C condenser fan do not run at high speed when the engine coolant temperature is above 199 T (93 °C) Check for open in the wire between A/C condenser fan relay 4P socket terminal No. 3 and ECM connector terminal A5. Cleanliness and tightness of all connectors
scientia non olet · About LEMON Manuals