Ignition Switch Test

SRS components are located in the area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before performing repairs or servicing.

1. Do the battery terminal disconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
2. Remove the steering column covers (see PASSENGER'S DASHBOARD TRIM VENT ).
3. Disconnect the 5P connector (A) from the ignition switch (B).
   Fig 1: Identifying Ignition Switch 5P Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Check for continuity between the terminals in each switch position according to the table.
   Fig 2: Continuity Chart

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If the continuity does not agree with the table, replace the ignition switch (see TEST ).
6. Do the battery terminal reconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).