OPDS Sensor Initialization
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
When you replace a seat-back cover/pad, the SRS unit, and/or the ODS unit, initialize the OPDS sensor with the HDS.
NOTE:
- Before initializing the ODS unit, make sure the battery is fully charged.
- A new (uninitialized) ODS unit installed with a faulty OPDS sensor (DTC 86-1x or 86-2x) can cause DTCs 85-71 and 85-78. If the SRS has a hard DTC 86-1x or 86-2x, troubleshoot the DTCs completely before replacing the ODS unit.
- Before initializing the ODS unit, clear the DTCs.
- Make sure all Components of the front passenger's seat are correctly installed.
- Make sure nothing is on the front passenger's seat, including after market seat covers or mats.
- Make sure there is nothing in the front passenger's seat-back pocket.
- Keep the A/C and the heater off.
- Turn the ignition switch to ON (II).
- Set the seat-back in a normal position.
- Turn the ignition switch to LOCK (0).
- Connect the HDS to the data link connector (DLC) (A).
- Turn the ignition switch to ON (II).
- Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING ).
- From the HDS Main Menu, select SRS, then INITIALIZATION. In the INITIALIZATION Menu, select ODS Initialization. Follow the prompts until the OPDS sensor initialization has been completed.
- Turn the ignition switch to LOCK (0), then wait for 10 seconds.
- Disconnect the HDS from the DLC.NOTE: If the ODS unit fails to initialize after several attempts, replace the seat-back cover/pad equipped with an OPDS sensor (see FRONT SEAT-BACK COVER REPLACEMENT ), and retry. If the ODS unit continues to fail to initialize, replace the ODS unit (see ODS UNIT REPLACEMENT ).