LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2010 >> CR-V EX, 2.4 RE4 >> Repair and Diagnosis >> Engine Mechanical >> Auxiliary Emission Control Systems >> EVAP System >> EVAP Canister Replacement

EVAP Canister Replacement

  1. Raise the vehicle on a lift.
  2. Remove the cover (A).
    Fig 1: Identifying Cover
    G06610662Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the EVAP canister baffle cover (A).
    Fig 2: EVAP Canister Baffle Cover With Torque Specification
    G06610663Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the hoses (A) and the fuel subharness 6P connector (B).
    Fig 3: Hoses And Fuel Subharness 6P Connector With Torque Specification
    G06610664Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the bolts (C) and the EVAP canister bracket (D).
  6. Remove the EVAP canister (A) from the EVAP canister bracket (B).
    Fig 4: EVAP Canister And EVAP Canister Bracket With Torque Specification
    G06610665Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the cap (A).
    Fig 5: Identifying Cap And EVAP Canister Vent Shut Valve
    G06610666Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Remove the EVAP canister vent shut valve (B).
  9. Install the EVAP canister vent shut valve into the new EVAP canister with new O-rings (C).
    NOTE: Do not coat the O-rings with oil.
  10. Install the parts in the reverse order of removal.
scientia non olet · About LEMON Manuals