LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2010 >> CR-V EX, 2.4 RE3 >> Repair and Diagnosis >> Engine Performance >> System >> PGM-FI System >> ECT Sensor 2 Replacement

ECT Sensor 2 Replacement

  1. Remove the front splash shield, (see FRONT SPLASH SHIELD REPLACEMENT )
  2. Drain the engine coolant (see COOLANT CHECK ).
  3. Disconnect the ECT sensor 2 connector (A), then remove ECT sensor 2 (B).
    Fig 1: ECT Sensor 2 Connector, ECT Sensor 2 And O-Ring With Torque Specification
    G06610410
  4. Install ECT sensor 2 with a new O-ring (C).
  5. Install the front splash shield, (see FRONT SPLASH SHIELD REPLACEMENT )
  6. Refill the radiator with engine coolant (see COOLANT CHECK ).
scientia non olet · About LEMON Manuals