LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2009 >> S2000 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Relays) >> Power Relay Test >> Special Tools Required

Special Tools Required

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 Honda S2000, 2007 Honda S2000, 2006 Honda S2000, 2005 Honda S2000, and 2004 Honda S2000. However, it is still accessible from the selected car via links, so may be relevant.

Relay puller 07AAC-000A1A0 

Use this table to identify the type of relay, then do the test listed for it. Carefully remove the relays using the relay puller. Do not use pliers. Pliers will damage the relay

Fig 1: Identifying Relay Puller
G00455411Courtesy of AMERICAN HONDA MOTOR CO., INC.
NOTE: For the turn signal/hazard relay input test (see TURN SIGNAL/HAZARD RELAY INPUT TEST ).
RELAY INPUT TEST TABLE

Relay Test
A/C compressor clutch relay Normally open type A
A/C condenser fan relay
ETCS control relay(3)
Headlight relay 1
Headlight relay 2
High beam cut relay (Except '00-05 USA)
Horn relay
PGM-FI main relay 1(3)
PGM-FI main relay 2(3)
Radiator fan relay
Starter cut relay
Taillight relay
Rear window defogger relay(1)
Blower motor relay Normally open type B
Intermittent wiper relay(2) Five terminal type A
A/F sensor relay(3) Five terminal type B
Accessory power socket relay
IG2 relay
Ignition coil relay(3)
Intermittent wiper relay(1)
Rear window defogger change relay(2)
Rear window defogger relay(2)
(1) '00-01 models
(2) '02-09 models
(3) '06-09 model