LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2009 >> Element SC, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Front And Rear Suspension - Inspection And Alignment) >> Wheel Bolt Replacement >> Front

Wheel Bolt Replacement: Front

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front hub bearing unit (see HUB BEARING UNIT REPLACEMENT ).
  2. Separate the wheel bolt (A) from the hub (B) using a hydraulic press. Support the hub with hydraulic press attachments (C) or equivalent tools.
    NOTE: Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
    Fig 1: Identifying Hub Wheel Bolt
    G06969569Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Insert the new wheel bolt into the hub while aligning the splined surfaces on the hub hole with the wheel bolt.
    NOTE:
    • Degrease the area around the wheel bolt.
    • Make sure the wheel bolt is installed vertically to the hub disc surface.
  4. Install the wheel bolt using a hydraulic press until the wheel bolt shoulder is fully seated.
  5. Install the front hub bearing unit (see HUB BEARING UNIT REPLACEMENT ).
    NOTE: If you cannot tighten the wheel nut to the specified torque when installing the wheel, replace the front hub bearing unit as an assembly.
scientia non olet · About LEMON Manuals