Decelerating In Reverse Gears (4WD Mode)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Honda Crosstour, 2014 Honda Crosstour, 2013 Honda Crosstour, 2012 Honda Crosstour, and 2011 Honda Accord Crosstour. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Accord Cross tour has no rear jacking bracket. Do not use the rear differential assembly, the rear subframe, or rear suspension components as jacking points. Use the following procedure to avoid damaging the vehicle.
- Place the block on the right front wheel.
- Position the floor jack under the vehicle's front support point (A). Center the jack lift platform (B) on the support point, and jack up the vehicle high enough to fit a safety stand (C) under the vehicle's rear support point (D).
- Carefully lower the jack until the rear support point contacts the safety stand, then remove the jack.
- Block the left front wheel.
- Hold the left rear tire, and turn it clockwise continuously for more than one rotation.
- If the wheel does not rotate, the 4WD system when decelerating in reverse gear is normal.
- If the wheel rotates, there is a problem in the system. Check the differential fluid. If the fluid is normal, replace the torque control differential (TCD) case kit.