DTC P0711: Problem in ATF Temperature Sensor Circuit
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Honda Crosstour, 2014 Honda Crosstour, 2013 Honda Crosstour, 2012 Honda Crosstour, and 2011 Honda Accord Crosstour. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION ).
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
- Turn the ignition switch to ON (II).
- Check the ATF Temperature with the HDS in the A/T Data List.
Does the ATF Temperature with indicate -4 °F (-20 °C) or higher?
YES -Intermittent failure, the system is OK at this time.
NO -Go to next step.
- Start the engine, and wait for at least 10 minutes. Test the stall speed RPM (see STALL SPEED TEST ) three times.
- Check the ATF Temperature with the HDS in the A/T Date List.
Does the ATF Temperature with indicate -4°F (-20°C) or below?
YES -Replace the ATF temperature sensor (see ATF Temperature Sensor Replacement ).
NO -Intermittent failure, the system is OK at this time.