Ignition Coil and Spark Plug Removal/Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine cover (see step 7 on ENGINE REMOVAL ).
Disconnect the ignition coil connectors (A), then remove the ignition coils (B).
FRONT

Fig 1: Ignition Coil Connectors And Ignition Coils With Torque Specifications (FRONT)
Courtesy of AMERICAN HONDA MOTOR CO., INC.

REAR

Fig 2: Ignition Coil Connector And Ignition Coils With Torque Specifications (REAR)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the spark plugs (C) and inspect them (see SPARK PLUG INSPECTION ).
Apply a small amount of anti-seize compound to the plug threads, and screw the plugs into the cylinder head, finger-tight, then tighten the plugs to the specified torque.
Specified Torque:

22 N.m (2.2 kgf.m, 16 lbf.ft)
Install the ignition coils in the reverse order of removal.