Gearbox Mount Cushion Replacement

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

Remove the steering gearbox (see STEERING GEARBOX REMOVAL AND INSTALLATION ).
Position a 34 mm socket (A) on the flange part of the gearbox housing with a washer (B), a 10 x 105 mm flange bolt (C), and a 10 mm nut (D) as shown.

Fig 1: Positioning Socket On Flange Part Of Gearbox Housing With Washer, Flange Bolt And Nut
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Hold the flange bolt with a wrench, and tighten the nut with a wrench. Remove the gearbox mount cushion (E).
Apply a mild soap and water solution to the new gearbox mount cushion surface (A), then place the mount cushion on the gearbox mounting cushion hole.

Fig 2: Identifying Gearbox Mount Cushion Surface And Socket
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Position a 34 mm socket (B) on the flange part of the gearbox housing with a washer, a flange bolt, and a nut as shown.
Install the gearbox mount cushion by tightening the nut until the mount cushion edge (A) properly fits on the gearbox flange surface (B).

Fig 3: Identifying Gearbox Mount Cushion Edge And Gearbox Flange Surface
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the steering gearbox (see INSTALLATION ).