Ignition Switch Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or servicing.

1. Do the battery terminal disconnection procedure (see DISCONNECTION ).
2. Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ) and the steering column covers (see STEERING COLUMN REMOVAL AND INSTALLATION ).
3. Disconnect the 7P connector (A) from the ignition switch (B).
   Fig 1: Identifying Ignition Switch And 7P Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the two screws and the ignition switch.
5. Install the ignition switch in the reverse order of removal.
6. Do the battery terminal reconnection procedure (see RECONNECTION ).