Passenger's Power Window Switch Test

Remove the passenger's door panel.
- Front (see FRONT DOOR PANEL REMOVAL/INSTALLATION )
- Rear (see REAR DOOR PANEL REMOVAL/INSTALLATION )
Disconnect the 8P connector (A) from the passenger's power window switch (B).
Front passenger's

Fig 1: Locating Passenger's Power Window Switch 8P Connector - Front Passenger'S
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Rear

Fig 2: Locating Passenger's Power Window Switch 8P Connector - Rear
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.

Fig 3: Passenger's Power Window Switch Terminals Continuity Reference Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect battery power to terminal No. 4 and ground terminal No. 7 (or No. 8). The switch light should come on.
If the continuity or switch light tests is not as specified, replace the switch (see POWER WINDOW SWITCH REPLACEMENT ).