Countershaft Bearing Replacement

Special Tools Required 

• Adjustable bearing puller, 25-40 mm 07736-A01000B or 07736-A01000A
• Driver 07749-0010000
• Attachment, 78 x 80 mm 07NAD-PX40100

1. Remove the countershaft bearing from the torque converter housing with the adjustable bearing puller and a commercially available 3/8 "-16 slide hammer (A).
   Fig 1: Removing Countershaft Bearing Using Special Tool

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install the ATF guide plate (A) into the housing, then install the new bearing (B) in the direction shown.
   Fig 2: Identifying Bearing And ATF Guide Plate

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the bearing (A) in the housing with the driver and attachment (78 x 80 mm); install bearing outer race notch-cut (B) to a depth (C) of 0-0.03 mm (0-0.001 in.) below the housing surface (D).
   Fig 3: Installing Bearing In Housing Using Special Tools

   Courtesy of AMERICAN HONDA MOTOR CO., INC.