VSA OFF Switch Test

WARNING: This page is about a different car, the 2008 Honda Pilot, 2007 Honda Pilot, and 2006 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

Make sure the ignition switch OFF.
Remove the switch panel (A).

Fig 1: Identifying VSA OFF Switch And Switch Panel
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the VSA OFF switch 13P connector (B).
Remove the VSA OFF switch (C) from the switch panel.
Check for continuity between the VSA OFF switch 13P connector terminals No. 11 and No. 12. There should be continuity when the switch is pressed, and no continuity when the switch is released.

Fig 2: Checking Continuity Between VSA Off Switch 13P Connector Terminals No. 11 And No. 12
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the VSA OFF switch 13P connector terminals No. 1 and No. 5. There should be continuity at all times.

Fig 3: Checking Continuity Between VSA Off Switch 13P Connector Terminals No. 1 And No. 5
Courtesy of AMERICAN HONDA MOTOR CO., INC.