LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2008 >> Pilot SE, 3.5 YF2 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> ATF Temperature Sensor Replacement

ATF Temperature Sensor Replacement

  1. Remove the splash shield.
  2. Drain the automatic transmission fluid (ATF) (see step  3 ).
  3. Disconnect the ATF temperature sensor connector (A), then remove the connector from the connector bracket (B).
    Fig 1: Locating ATF Temperature Sensor With Torque Specifications
    G05593983Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the harness clamp (C) from its bracket (D).
  5. Remove the ATF temperature sensor (E).
  6. Install a new O-ring (F) on the new ATF temperature sensor, and install the ATF temperature sensor.
  7. Check the connector for rust, dirt, or oil. Connect the connector securely, and install it on its bracket.
  8. Install the harness clamp on its bracket.
  9. Refill the transmission with the ATF (see step  5 ).
  10. Install the splash shield.
scientia non olet · About LEMON Manuals