Hazard Warning Switch: Inspection
WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT HAZARD WARNING SWITCH
- Check the resistance.
- Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in HAZARD WARNING SWITCH .
Standard
HAZARD WARNING SWITCHTester Connection Condition Specified Condition 7-9 OFF 10 k or higher 7-9 ON Below 1 10-11 Illumination circuit Below 1 If the result is not as specified, replace the hazard warning signal switch assembly.
- Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in HAZARD WARNING SWITCH .
- Check the illumination operation.
- Connect the battery positive (+) lead to terminal 11 and the battery negative (-) lead to terminal 10, then check that the illumination comes on.
Standard: Illumination comes on.
If the illumination does not come on, replace the bulb.
- Connect the battery positive (+) lead to terminal 11 and the battery negative (-) lead to terminal 10, then check that the illumination comes on.
- Check the resistance.