ATF Cooler Line and Hose Assembly Replacement
- Disconnect the ATF cooler hose (A) from the ATF cooler line (B).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Disconnect the ATF cooler hose (C) from the ATF cooler line (D).
- Loosen the bolt (E) securing the cooler line bracket, and remove the bolt (F) securing the cooler line bracket.
- Remove the cooler hose clamp (G) from the clamp bracket.
- Install a new ATF cooler line and hose assembly (H).
- Slide the hose end (I) over the cooler line on the ATF cooler under the radiator until the hose end contacts the bend in the line.
- Secure the hose with the clip (J) at 2-4 mm (0.1-0.2 in.) (K) from the hose end.
- Slide the ATF cooler hose over the ATF cooler line until the hose end contacts with the bulge (L).
- Secure the hose with the clip (M) at 6-8 mm (0.2-0.3 in.) (N) from the hose end.
- Install the cooler hose clamp at the mark (O), then install the clamp on the clamp bracket.