LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Pilot LX, 3.5 YF1 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> ATF Level Check

ATF Level Check

NOTE: Keep all foreign particles out of the transmission.
  1. Park the vehicle on the level ground.
  2. Warm up the engine to normal operating temperature (the radiator fan conies on), and turn the engine OFF. Do not allow the engine to warm up longer than the time it takes for the radiator fan to comes on twice.
    NOTE: Check the fluid level within 60-90 seconds after turning the engine off. Higher fluid level may be indicated if the radiator fan comes on twice or more.
  3. Remove the dipstick (yellow loop) (A) from the dipstick guide tube, and wipe it with a clean cloth.
    Fig 1: Locating Dipstick (Yellow Loop)
    G05593984Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Insert the dipstick into the guide tube.
  5. Remove the dipstick (A) and check the fluid level. It should be between the upper mark (B) and lower mark (C).
    Fig 2: Locating Dipstick Fluid Level Upper Mark And Lower Mark
    G05593985Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. If the level is below the lower mark, check for fluid leaks at the transmission, hose and line joints, and cooler lines. If a problem is found, fix it before filling the transmission.
    NOTE: If the vehicle is driven when the ATF level is below the lower mark:
    • The transmission damage will result.
    • Vehicle does not move in any gear.
    • Vehicle accelerates poorly and flares when starting off in the D and R positions.
    • The engine vibrates at idle.
  7. If the level is above the upper mark, drain the ATF to proper level (see ATF REPLACEMENT  ).
    NOTE: If the vehicle is driven when the ATF level is above the upper mark, vehicle moves in the N position, and shifting malfunction will occur.
  8. If necessary fill the transmission with the ATF through the filler hole (A) to bring the fluid level midway between the upper mark and lower mark of the dipstick. Do not fill the fluid to excess of the upper mark. Always use Honda ATF-Z1 Automatic Transmission Fluid (ATF). Using a non-Honda ATF can affect shift quality.
    Fig 3: ATF Filler Bolt And Sealing Washer With Torque Specifications
    G05593986Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Install the ATF filler bolt (B) and a new sealing washer (C).
scientia non olet · About LEMON Manuals