LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Pilot EX, 3.5 YF1 >> Repair and Diagnosis >> Brakes >> Traction Control >> VSA (Vehicle Stability Assist) System Components >> DTC Troubleshooting >> DTC 84: VSA Sensor Neutral Position

DTC 84: VSA Sensor Neutral Position

  1. Turn the ignition switch ON (II).
  2. Clear the DTC with the HDS.
  3. Turn the ignition switch OFF, then disconnect the HDS.
  4. Test-drive the vehicle.
  5. Check for DTCs with the HDS.

    Is DTC 84 indicated? 

    YES  -Go to step 6.

    NO  -Intermittent failure, the system is OK at this time (see INTERMITTENT FAILURES  ).

  6. Check for other system DTCs with the HDS. Are any other DTCs indicated?

    YES  -Troubleshoot the appropriate DTC.

    NO  -Go to step 7.

  7. Do the VSA sensor neutral position memorization (see VSA SENSOR NEUTRAL POSITION MEMORIZATION  ).
  8. Clear the DTC with the HDS.
  9. Turn the ignition switch OFF, then disconnect the HDS.
  10. Test-drive the vehicle.
  11. Check for DTCs with the HDS.

    Is DTC 84 indicated? 

    YES  -Check for loose terminals in the VSA modulator-control unit 47P connector. If necessary, substitute a known-good VSA modulator-control unit (see VSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION  ), and retest.

    NO  -Intermittent failure, the system is OK at this time (see INTERMITTENT FAILURES  ).

scientia non olet · About LEMON Manuals