LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Odyssey EX >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> A/T Differential >> Backlash Inspection

Backlash Inspection

  1. Remove the final driven gear from the differential carrier.
  2. Install both axles into the differential assembly (A), and place the axles on V-blocks (B).
    Fig 1: Identifying Differential Assembly And V-blocks
    G06681253Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Measure the backlash of the pinion gears (C) using a dial indicator (D).

    Standard: 0.05-0.15 mm (0.002-0.006 in) 

  4. If the backlash is out of the standard, replace the differential carrier.
  5. Install the final driven gear on the differential carrier (see DIFFERENTIAL CARRIER AND FINAL DRIVEN GEAR REPLACEMENT  ).
scientia non olet · About LEMON Manuals