LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Odyssey EX >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Block >> Oil Pan Installation

Oil Pan Installation

  1. Remove all of the old liquid gasket from the oil pan mating surfaces, the bolts, and the bolt holes.
  2. Clean and dry the oil pan mating surfaces.
  3. Apply liquid gasket, P/N 08717-0004,08718-0001, 08718-0003, or 08718-0009, evenly to the oil pan mating surface of the engine block. Install the component within 5 minutes of applying the liquid gasket.
    NOTE:
    • If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
    • If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.
    Fig 1: Applying Liquid Gasket To Oil Pan Mating Surface Of Engine Block
    G05523462Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the oil pan on the engine block.
  5. Tighten the bolts in three steps. In the final step, tighten all bolts, in sequence, to 12 N.m (1.2 kgf.m, 8.8 lbf.ft).
    NOTE:
    • Wait at least 30 minutes before filling the engine with oil.
    • Do not run the engine for at least 3 hours after installing the oil pan.
    Fig 2: Identifying Oil Pan Bolts In Sequence
    G05523463Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Tighten the four bolts (A) securing the transmission, then install the torque converter cover (B).
    Fig 3: Bolts And Torque Converter Cover With Torque Specifications
    G05523464Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. '08-09 models J35A7 engine: Connect the crankshaft position (CKP) sensor connector (A), then install the CKP sensor cover (B) and the bolt (C).
    Fig 4: Crankshaft Position (CKP) Sensor Connector, CKP Sensor Cover And Bolt With Torque Specifications
    G05523465Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Install the rear warm up three way catalytic converter (rear WU-TWC) bracket.
    Fig 5: Rear Warm Up Three Way Catalytic Converter (Rear WU-TWC) Bracket With Torque Specifications
    G05523466Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. If the engine is still in the vehicle, do the following steps.
  10. Install exhaust pipe A using new gaskets and new self-locking nuts (see step 38 on ENGINE INSTALLATION ).
  11. Install the splash shield (see step 39 on ENGINE INSTALLATION ).
  12. Refill the engine with engine oil (see step 4 on ENGINE OIL REPLACEMENT ).
scientia non olet · About LEMON Manuals