Fuel Pump: Disassembly

WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FUEL SENDER GAUGE ASSEMBLY
1. Disconnect the connector.
  
  Fig 1: Disconnecting Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disengage the claw fitting and remove the sender gauge by sliding it in the direction as shown in Fig 2.
  
  Fig 2: Removing Sender Gauge
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 FUEL SUB-TANK
1. Disengage the 5 claw fittings and remove the fuel pump tank.
  
  Fig 3: Disengaging Claw Fittings & Removing Fuel Pump Tank
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Separate the connector and disengage the clamp.
  
  Fig 4: Separating Connector & Disengaging Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FUEL PUMP ASSEMBLY
1. Disengage the clamp, then disconnect the connector.
  
  Fig 5: Disengaging Clamp & Disconnecting Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disengage the 5 claw fittings and separate the fuel pump from the fuel pump case.
  
  Fig 6: Separating Fuel Pump From Fuel Pump Case
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the connector from the fuel pump.
  
  Fig 7: Disconnecting Connector From Fuel Pump
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FUEL PUMP FILTER
1. Remove the fuel filter from the fuel pump.
  
  Fig 8: Removing Fuel Filter From Fuel Pump
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
1. Remove the fuel pressure regulator and the 2 O-rings.
  
  Fig 9: Removing Fuel Pressure Regulator & O-Rings
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002