LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Fit Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> 3rd Clutch Transmission Fluid Pressure Switch Replacement

3rd Clutch Transmission Fluid Pressure Switch Replacement

  1. Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
  2. Remove the splash shield.
  3. Disconnect the 3rd clutch transmission fluid pressure switch connector, then remove the 3rd clutch transmission fluid pressure switch (A).
    Fig 1: 3rd Clutch Transmission Fluid Pressure Switch Connector With Torque Specification
    G05455325
  4. Install the new 3rd clutch transmission fluid pressure switch with a new sealing washer (B), and tighten the metal part of the switch.
  5. Check the connector for rust, dirt, or oil, then connect the connector securely.
  6. Install the splash shield.
scientia non olet · About LEMON Manuals