Front Speed Sensor: Installation

WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT SPEED SENSOR
1. Install the front speed sensor with the bolt.
  Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf)
  
  NOTE: Make sure that the sensor tip is clean.
2. Connect the speed sensor connector.
INSTALL FRONT WHEEL
Torque: 113 N*m (1,152 kgf*cm, 83 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)

(See PRECAUTION )
CHECK VSC SENSOR SIGNAL (w/ VSC)
(See TEST MODE PROCEDURE )
CHECK ABS SENSOR SIGNAL (w/o VSC)
(See TEST MODE PROCEDURE )