LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Fit Base, Automatic >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Clutch Interlock Switch Test >> Starter Solenoid Test

Starter Solenoid Test

  1. Make sure you have the anti-theft code for the audio system, and that the ignition switch is OFF.
  2. Disconnect the negative cable from the battery.
  3. Remove the starter cable terminal (A), BLK/WHT wire connector (B), and motor cable (C).
    Fig 1: Identifying Starter Cable Terminal, BLK/WHT Wire Connector And Motor Cable
    G05454001Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). There should be continuity.
    • If there is continuity, go to step  5.
    • If there is no continuity, replace the solenoid.
  5. Check the pull-in coil for continuity between the S terminal and the M terminal. There should be continuity.
    • If there is continuity, the solenoid is OK.
    • If there is no continuity, replace the solenoid.
  6. Install in the reverse order of removal.
  7. Connect the negative cable to the battery.
  8. Enter the anti-theft code for the audio system.
  9. Set the clock.
scientia non olet · About LEMON Manuals