Transfer Holder Disassembly

Cut the locking tab of the transfer shaft locknut using a chisel. Keep all of the chiseled particles out of the transfer shaft assembly.

Fig 1: Cutting Locking Tab Of Transfer Shaft Locknut With Chisel
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Hold the transfer shaft assembly (A) with a 14 mm hex wrench (B) clamped in a bench vise, then loosen the transfer shaft locknut.

Fig 2: Holding Transfer Shaft Assembly With Wrench
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the transfer shaft locknut (A), conical spring washer (B), 57 mm tapered roller bearing (C), 25 mm thrust shim (D), transfer collar (E), transfer drive gear (F), and transfer shaft assembly (G) from the transfer holder (H).

Fig 3: Identifying Transfer Shaft Locknut, Conical Spring Washer, Tapered Roller Bearing & Thrust Shim
Courtesy of AMERICAN HONDA MOTOR CO., INC.