Transfer Output Shaft Bearing Removal/Installation

Special Tools Required 

• Driver handle, 40 mm I.D. 07746-0030100
• Attachment, 35 mm I.D. 07746-0030400

1. Remove the tapered roller bearing (A) from the transfer output shaft (B) using a bearing separator (C) and a press. Place a shaft protector (D) between the transfer output shaft and the press to prevent damaging the transfer output shaft.
   Fig 1: Removing Tapered Roller Bearing From Transfer Output Shaft

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install the 35 mm thrust shim (A) on the transfer output shaft (B).
   Fig 2: Installing Thrust Shim On Transfer Output Shaft

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the tapered roller bearing (C) on the transfer output shaft using the 40 mm I.D. driver handle, the 35 mm I.D. attachment, and a press.