Secondary Shaft Bearing Replacement

Special Tools Required 

• Driver handle, 15 x 135L 07749-0010000
• Attachment, 62 x 68 mm 07746-0010500

1. Remove the set plate bolt, then remove the lock washer (A) and the bearing set plate (B).
   Fig 1: Identifying Lock Washer And Bearing Set Plate

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the secondary shaft bearing (A) by heating the torque converter housing to about 212°F (100°C) using a heat gun (B). Do not heat the torque converter housing more than 212°F (100°C).
   NOTE: Let the torque converter housing cool to normal temperature before installing the secondary shaft bearing.
   Fig 2: Identifying Secondary Shaft Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the ATF guide collar with the O-rings. Clean and dry the ATF guide collar surfaces in the torque converter housing if necessary.
4. Install new O-rings (A) on the ATF guide collar (B), then install the ATF guide collar in the torque converter housing.
   Fig 3: Identifying O-rings And ATF Guide Collar

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Install a new secondary shaft bearing (C) in the direction shown.
6. Install the secondary shaft bearing using the driver handle and 62 x 68 mm attachment, and install it securely in the torque converter housing.
   Fig 4: Identifying Secondary Shaft Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Check that the bearing groove aligns with the torque converter housing surface, then install the bearing set plate with aligning the bearing groove.
8. Install a new lock washer and the set plate bolt, then bend the lock tab of the lock washer against the bolt head.