Engine Oil Replacement

Warm up the engine.
Remove the drain bolt (A), and drain the engine oil.

Fig 1: Drain Bolt And Washer With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reinstall the drain bolt with a new washer (B).
Refill the engine with the recommended oil (see LUBRICANTS AND FLUIDS ).
Capacity

At Oil Change:

4.0L(4.2 US qt)

At Oil Change Including Filter:

4.2 L (4.4 US qt) After Engine Overhaul:

5.3 L (5.6 US qt)

Fig 2: Refilling Engine Oil
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 under HOW TO USE THE HDS (HONDA DIAGNOSTIC SYSTEM) ).
Turn the ignition switch to ON (II).
Make sure the HDS communicates with the vehicle and the powertrain control module (PCM). If it doesn't troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
Select the BODY ELECTRICAL with the HDS.
Select the ADJUSTMENT in GAUGE MENU with the HDS.
Select the RESET in the MAINTENANCE MINDER with the HDS.
Select the RESETTING THE ENGINE OIL LIFE with the HDS.
NOTE: If you changed the automatic transmission fluid (ATF) at the same time with the engine oil, select RESETTING THE ENGINE OIL LIFE AND ATF with the HDS instead.
Run the engine for more than 3 minutes, then check the oil level and oil leaks.