DTC P0727: Problem in Engine RPM Signal Input Circuit (No Signal Input): General Description
The transmission control module (TCM) converts the engine ignition signal into the engine speed signal. The CVT input shaft (drive pulley) speed sensor detects the number of revolutions of the gear on the drive pulley and outputs a pulsing signal to the TCM. The TCM converts the pulsing signal into the drive pulley speed.
When the shift lever is in D, L, or R, and at a specified value of the drive pulley speed or more, and there is no engine speed signal input, a malfunction is detected and a DTC is stored.
MONITOR DESCRIPTION CHART
| Execution | Continuous |
| Sequence | None |
| Duration | 10 seconds or more |
| DTC Type | One drive cycle, MIL ON, D indicator blinks |
ENABLE CONDITIONS CHART
| Condition | Minimum | Maximum | ||||
|---|---|---|---|---|---|---|
| Drive pulley speed | 576 rpm(1) | - | ||||
| 323 rpm(2) | ||||||
| Manifold absolute pressure | - | 67 kPa (510 mmHg, 20.0 in.Hg) | ||||
| Shift lever position | D, L, or R | |||||
| No active DTCs | Transmission range switch, CVT input shaft (drive pulley) speed sensor, CVT output shaft (driven pulley) speed sensor | |||||
|
||||||