DTC P0716: Range/Performance Problem in CVT Input Shaft (Drive Pulley) Speed Sensor Circuit: General Description
The CVT input shaft (drive pulley) speed sensor detects the number of revolutions of the gear on the drive pulley and sends a pulsing signal to the transmission control module (TCM). The TCM converts the pulsing signal into drive pulley speed. In addition, the TCM converts the engine ignition signal into the engine speed signal.
If the drive pulley speed is lower than the value that is estimated based on the engine speed in D, L, or R position, a malfunction in the CVT input shaft (drive pulley) speed sensor is detected and a DTC is stored.
MONITOR DESCRIPTION CHART
| Execution | Continuous |
| Sequence | None |
| Duration | 15 seconds or more |
| DTC Type | One drive cycle, MIL ON, D indicator blinks |
ENABLE CONDITIONS CHART
| Condition | Minimum | Maximum |
|---|---|---|
| Engine speed | 576 rpm | - |
| Driven pulley speed | 128 rpm | - |
| Shift lever position | D, L, or R | |
| No active DTCs | Transmission range switch, CVT output shaft (driven pulley) speed sensor, Engine RPM signal input circuit | |